Remote Commands and Syntax
Commands 6
6-13
Table 6-4. Command Summary by Function (cont.)
Remote Interface Parameter Setting Commands
SP_EOF Sets the End-Of-File (EOF) string
SP_EOF? Returns the End-Of-File (EOF) string
SP_SET
Sets baud, terminal or computer mode, stall method, data bits, stop bits,
parity, and End-Of-Line (EOL) string
SP_SET?
Returns baud rate, terminal or computer mode, stall method, data bits, stop
bits, parity, and End-Of-Line (EOL) string
ADDR Set GPIB address
ADDR? Returns the GPIB address
DHCP Turns on/off DHCP
DHCP? Returns the state of the DHCP setting
ENETPORT Sets Ethernet port
ENETPORT? Returns the Ethernet port setting.
EOL Sets EOL for given port
EOL? Gets EOL for given port
GWADDR Sets gateway address
GWADDR? Returns the gateway address.
IPADDR Sets IP address
IPADDR? Returns the IP address
MACADDR? Gets MAC address
REM_MODE Sets computer/terminal mode for given port
REM_MODE? Gets computer/terminal mode for given port
SUBNETMASK Sets subnet mask
SUBNETMASK? Returns the subnet mask
To Next Page
Loading...
