5730A
Operators Manual
6-14
Table 6-4. Command Summary by Function (cont.)
Calibration, Testing, and Diagnostics Commands for the Calibrator
CAL_ADJ Does the internal portion of calibration
CAL_CHK Starts calibration check
CAL_CLST? Returns a group of calibration constant names and their values
CAL_CONF Sets the calibration specifications to a confidence level of either 95 % or
99 %
CAL_CONF? Returns the current calibration confidence level
CAL_CONST? Returns the value of a particular constant
CAL_COUNT? Number of times the Calibrator has been unsecured
CAL_DATE? Returns the date of the most recent calibration
CAL_DAYS? Returns the days elapsed since last calibration recall
CAL_INTV Sets the calibration interval
CAL_INTV? Returns the calibration interval
CAL_PASSWD Change the calibration passcode
CAL_REF Does a calibration procedure with a 1 Ω, 10 kΩ, or 10 V standard
CAL_RCSV?
Returns a comma-separated-value format report similar to what is saved on
a USB flash drive
CAL_RNG Starts a self-calibration procedure of a range
CAL_RPT? Returns a formatted calibration report
CAL_SECURE Locks/unlocks calibration security
CAL_SECURE? Gets lock state of calibration security
CAL_SHIFT? Returns the shift of a range due to a calibration action
CAL_SLST? Returns the shifts of a group of ranges
CAL_STORE Stores new calibration constants in nonvolatile memory
CAL_TEMP Sets the temperature for calibration
CAL_TEMP? Returns the calibration temperature last specified
CAL_USB Saves the calibration report to a USB flash drive
CAL_WBFLAT Does Wideband AC Module (Option 5730A/03 or 5730A/05) flatness
calibration
CAL_WBGAIN Does Wideband AC Module (Option 5730A/03 or 5730A/05) gain calibration
CAL_ZERO Does internal zeros calibration
DIAG Runs self-diagnostics
To Next Page
Loading...
