Fluke 5730A - Page 170

5730A
Operators Manual
6-44
Table 6-5. Commands (cont.)
STATE?
Description
Sequential command.
Returns the long-term state of the Calibrator.
Parameter None
Response
1. (Integer) Gross state, with the subsequent responses:
0 Operating 10 Calibration, wideband positive gain
1 Self diagnostics 11 Calibration, wideband negative gain
2 Self diagnostics halted by a fault 12 Wideband flatness calibration,
adjustment
3 Calibration check 13 Wideband flatness calibration,
reference point
4 DC zeros calibration 14 Range calibration
5 Calibration, +dc reference 15 5725A voltage diagnostics
6 Calibration, -dc reference 16 5725A current troubleshooting
7 Calibration, 1 Ω reference 17 Reserved
8 Calibration, 10 kΩ reference 18 Reserved
9 Calibration, internal adjustment 19 Analog output tripped to dormant
2. (String) Substate: 20. Starting up
If operating, self-calibrating, diagnosing, or testing, returns a descriptive string of
the activity underway.
*STB?
Description
Sequential command.
Returns the status byte. The status byte is described under "Status Information."
Parameter None
Response (Integer) Decimal equivalent of the status byte.
Example
*STB?
Returns: "72" if bits 3 (EAV) and 6 (MSS) are set (1) and the rest of the bits are reset (0).
STBY
Description
Overlapped command, ignored if not in remote.
Puts the Calibrator in standby.
Parameter None
SUBNETMASK
Description
Sequential command. Ignored if not in remote. Sets Ethernet subnet mask for LAN
communication when NOT in DHCP mode.
Parameter
Subnet mask (quoted string consisting of 4 decimal values bound between 0-255
separated by periods).
Example
SUBNETMASK "255.255.254.0"
Sets the Ethernet subnet mask to 255.255.254.0