Fluke 5730A User Manual

5730A
Operators Manual
A-4
220 5725 -400 V Supply Too Small
221 5725 +400 V Supply Current Too High
222 Output Tripped To Standby
223 5725 -400 V Supply Current Too High
224 Output Tripped To Standby
225 5725 Fan Not Working
226 5725 CLAMPS Fault
227 Output Tripped To Standby
228 5725 Software TRAP
229 5725 Cable Was Off
230 5725 RESET (power-up or watchdog timer)
231 5725 Guard-Crossing Timeout
232 5725 Illegal/Unexecutable Command
233 5725 Non-Maskable Interrupt Occurred
234 5725 HVCLEAR Circuit Activated
235 Output Tripped To Standby
400-Level Faults: Calibration Constant
400 Bad Cal Constant ID
500-Level Faults: Configuration Finder
500 Bad Mode To CNFmodeRanges
501 Configuration Table Overflow
502 Bad Amplifier Type Selection
503 Bad Flat Constant Type Selection
504 Guard Crossing Error While Polling Assemblies
505 5725 Guard Crossing would not Start
700-Level Faults: Error Handling
700 Error Queue Overflow
701 Bad ERR Channel

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)