Fluke 5730A - Page 218

5730A
Operators Manual
A-8
1600-Level Faults: Guard Crossing Transmit
1600 Multiple Timeouts Sending To Inguard
1601 Inguard Request Reset Loop
1602 Unexpected NSA From Inguard
1603 Bad Packet Number In ACK From Inguard
1604 Bad Control Byte From Inguard Rcv Task
1605 Illegal Inguard Transmit Task State
1606 Inguard Indefinite ACKWAIT Holdoff
1700-Level Faults: Guard Crossing Utility
1700 Serial Write Failure To Inguard
1701 Packet Too Large For Inguard
1800-Level Faults: Normal Output Operations
1800 DORMANT To OPERATE
1801 Bad Transition Type
1802 Bad Boolean Selector
1803 NRMrngStby Encountered Error
1804 DCV Called For Non-DCV Range
1805 ACV Called For Non-ACV Range
1806 Bad ACV Frequency Range
1807 Hi Res Frequency Too High
1808 ACV Amplitude Correction Failure
1809 Cannot Phase Lock To Signal
1810 Bad Phase Quadrant
1811 Current Called for Non-Current Range
1812 Ohms Called for Non-Ohms Range
1813 Cannot Phase Lock, Output Not AC
1814 Cannot Phase Shift, Output Not AC
1815 Bad Wide Band Range
1816 Frequency Too High Even For Wide Band
1817 Illegal Current Output Location
1818 Output Current Out Of Tolerance
1819 Current Compliance Voltage Exceeded
1820 2-Wire Compensation Current Exceeded