Fluke 5730A - Page 219

Appendices
Fault Codes A
A-9
1821 NRMbstcur Passed Bad Range
1826 5725 No Longer Connected
1827 14-Bit DAC Scaling Found Zero Output
1900-Level Faults: Non-volatile
1900 Repaired Missing Or Corrupted NV Files
1903 Unknown Nonvolatile Constant Selector
1905 Could Not Write Byte To 5725 EEPROM
1906 Checksum Error Reading 5725 EEPROM
2000-Level Faults: Analog Operations Manager
2000 Bad Command Code
2001 Bad Signal
2002 Long Term Command In Progress
2003 Guard Crossing Protocol Failed To Start
2004 Fatal Fault, Output Tripped
2200-Level Faults: Remote Interface
2200 Unknown Command
2201 Invalid Number Of Parameters
2202 Invalid Cal Constant Name
2203 Invalid Keyword
2204 Invalid Range
2205 Invalid Parameter Type
2206 Invalid Parameter Unit
2207 Invalid Parameter Value
2208 IEEE488.2 I/O DEADLOCK
2210 IEEE488.2 INTERRUPTED Query
2211 Not Allowed From GPIB Interface
2212 Not Allowed From Serial Interface
2213 Remote Only
2214 Invalid Syntax
2215 IEEE488.2 UNTERMINATED Command
2216 Symbol Table Overflow
2218 Invalid Binary Number