5730A
Operators Manual
A-10
2219 Invalid Binary Block
2220 Invalid Character
2221 Invalid Decimal Number
2222 Invalid Hexadecimal Block
2223 Invalid Hexadecimal Number
2224 Too Many Parameters
2225 Invalid Octal Number
2226 Too Many Characters
2227 Invalid String
2228 Invalid Register Address
2229 Invalid Cal Constant Name
2230 Remote Serial Port Dead
2231 IEEE488.2 Query After Indef Response
2232 OPER Not Allowed While Fault Pending
2300-Level Faults: Report Generation
2300 Unknown Report Requested
2301 Unknown Report Device Requested
2302 Serial Port Timeout
2303 Could not find USB drive
2304 Could not open report file on USB drive
2400-Level Faults: Real Time Clock
2400 Could not read time and date.
2401 Could not set time and date.
2500-Level Faults: Self Calibration
2500 Invalid Cal Procedure Number
2501 Could not Ext Cal Gain
2502 Could not Ext Cal Ref
2503 Could not Ext Cal Neg
2504 Could not Cal Ratio
2505 Could not Cal Pos 11 V or 22 V DC Zero
2506 Could not Cal Neg 11 V or 22 V DC Zero
2507 Could not Cal Pos 11 V or 22 V DC Gain
2508 Could not Cal 6.5 V or 13 V Buf Ref
To Next Page
Loading...
