Fluke 5730A - Page 234

5730A
Operators Manual
A-24
4200-Level Faults: Instrument State Manager
4200 Bad Boolean Value Selector
4201 Meaningless Target State Value
4202 Meaningless Actual State Value
4203 Mystery Target/Actual State Difference
4204 Display Brightness Setting Exceeds Limits
4400-Level Faults: General Purpose Utility
4400 Invalid Command
4401 Floating Point Math Error
4500-Level Faults: Analog Value Finder
4500 VFdcDac Value Out Of DAC Range
4501 Bad Range Selector
4502 Non-Vfinder Range
4504 User Range Adjust of 0 (I used 1)
4505 Divide By 0 In (VF)correct
4700-Level Faults: Ethernet
4700 Port value out of range
4701 Could not open the ENET port
4702 Error reading from ENET port
4703 Ethernet address not valid
4704 Ethernet hostname not valid
4705 Ethernet hostname too long
4706 Cannot get DHCP IP address
4707 ENET Port 1
4708 ENET Remote Interface
4709 Port value already in use
4710 Cannot Change Ethernet Settings Now