Fluke 9190A - Page 64

9190A
Operators Manual
3-8
Table 3-4. Commands by Function or Group
Group Screen Parameter
Command
Password
Protection
Group
Read/Write
Calibration -
Controller
TEMP PB SOUR:LCON:PBAN Unconditional R/W
TEMP INT SOUR:LCON:INT Unconditional R/W
TEMP DER SOUR:LCON:DER Unconditional R/W
CALDATE CAL:DATE:UNIT Unconditional R/W
Calibration – Heat
Source
TEMP 1 SOUR:SENS:CAL:PAR1 Unconditional R/W
TEMP 2 SOUR:SENS:CAL:PAR2 Unconditional R/W
TEMP 3 SOUR:SENS:CAL:PAR3 Unconditional R/W
GRAD 1 SOUR:SENS:CAL:GRAD1 Unconditional R/W
GRAD 2 SOUR:SENS:CAL:GRAD2 Unconditional R/W
GRAD 3 SOUR:SENS:CAL:GRAD3 Unconditional R/W
TEMP 1 SOUR:SENS:CAL:TEMP1 N/A R
TEMP 2 SOUR:SENS:CAL:TEMP2 N/A R
TEMP 3 SOUR:SENS:CAL:TEMP3 N/A R
Calibration –
Reference
[-P]
REF1C0 SENS1:CAL:PAR1 Unconditional R/W
REF1C100 SENS1:CAL:PAR2 Unconditional R/W
INPUT CAL DATE CAL:DATE:MOD Unconditional R/W
Note:
[-P] – “-P” Model Only