Fluke 9190A - Page 65

Remote Operation
Remote Operation Commands 3
3-9
Table 3-4. Commands by Function or Group (cont.)
Group Screen Parameter
Command
Password
Protection
Group
Read/Write
Calibration – UUT
– TC
[-P]
TCC0 SENS2:CAL:PAR1 Unconditional R/W
TCC100 SENS2:CAL:PAR2 Unconditional R/W
TCCRJ SENS2:CAL:PAR3 Unconditional R/W
INPUT CAL DATE CAL:DATE:MOD Unconditional R/W
Calibration – UUT-
mA
mAC4 SENS2:CAL:PAR4 Unconditional R/W
mAC20 SENS2:CAL:PAR6 Unconditional R/W
INPUT CAL DATE CAL:DATE:MOD Unconditional R/W
Main Screen (none) SOUR:SENS:DATA N/A R
SETPT SOUR:SPO N/A R/W
SETPOINT 1 SOUR:LIST:SPO1 N/A R/W
SETPOINT 2 SOUR:LIST:SPO2 N/A R/W
SETPOINT 3 SOUR:LIST:SPO3 N/A R/W
SETPOINT 4 SOUR:LIST:SPO4 N/A R/W
SETPOINT 5 SOUR:LIST:SPO5 N/A R/W
SETPOINT 6 SOUR:LIST:SPO6 N/A R/W
SETPOINT 7 SOUR:LIST:SPO7 N/A R/W
SETPOINT 8 SOUR:LIST:SPO8 N/A R/W
STAB SOUR:STAB:DAT N/A R
STAB graph SOUR:STAB:TEST N/A R
(none) OUTP2:DATA N/A R
Main Screen
[-P]
REF CALC1:DATA N/A R
Main Screen
[-P]
REF TEMP READ, MEAS, FETC N/A R
UUT
[-P]
TC-n, P100, mA CALC2:DATA N/A R
Program – Run TEST STATUS PROG:STAT N/A R/W
Program - List (none) PROG:CAT N/A R
Program - Select (none) PROG:TYP N/A R/W
Program - Setup TEST ID PROG:IDEN N/A R/W
(none) PROG:MEM:COUN N/A R
Erase Tests ERASE TESTS PROG:MEM:CLEA Unconditional W
Note:
[-P] – “-P” Model Only