Fluke 9190A - Page 66

9190A
Operators Manual
3-10
Table 3-4. Commands by Function or Group (cont.)
Group Screen Parameter
Command
Password
Protection
Group
Read/Write
Ramp & Soak RAMP/SOAK SETUP PROG:SEQ:CAT N/A R
SETPOINT n PROG:SEQ:PAR SPOn Conditional R/W
SOAK TIME PROG:SEQ:PAR DWEL Conditional R/W
SETPOINTS PROG:SEQ:PAR POIN Conditional R/W
NO CYCLES PROG:SEQ:PAR CYCL Conditional R/W
PASS TOLERANCE PROG:SEQ:PAR PTOL Conditional R/W
DIRECTION PROG:SEQ:PAR DIR Conditional R/W
Test – Results
Main Screen
PRINT TEST PROG:MEM:PRINT N/A W
ERASE TESTS PROG:MEM:CLEA Unconditional W
Reference - List
[-P]
PROBE TYPE CALC1:CONV:CAT N/A R
Characterization
Parameters - Active
List (-P model only)
(none) CALC1:CONV:PAR:CAT N/A R
CAL DATE CALC1:CONV:DATE Conditional R/W
PROGRAM CALC1:CONV:PROG Unconditional W
Reference – Setup
[-P]
PROBE TYPE: ITS-90 CALC1:CONV:NAME ITS-90 Conditional R/W
Reference – Setup
[-P]
PROBE TYPE: CVD CALC1:CONV:NAME CVD Conditional R/W
Reference – Setup
[-P]
PROBE TYPE: IEC CALC1:CONV:NAME IEC-751 Conditional R/W
Reference – Setup
[-P]
CONV TYPE:
RESISTANCE
CALC1:CONV:NAME RES Conditional R/W
SERIAL CALC1:CONV:SNUM Conditional R/W
Note:
[-P] – “-P” Model Only