9190A
Operators Manual
3-28
SYST:PASS:PROT[?] [0|1]
Read or set password protection level.
[0] = low, [1] = high
Read Example: SYST:PASS:PROT?
Response: 0
Set Example: SYST:PASS:PROT 1
SYST:TIME[?] [<hh,mm,ss] (-P model only)
Note
This command is conditionally protected, that requires a password to set it.
Read or set the System Time <hh,mm,ss> (24 hr time only).
Range: hh = {0 – 23}, mm = {0 – 59}, ss = {0 – 59}
Example: SYST:TIME?
Response: 23,51,05
Set Example: SYST:TIME 14,15,05
UNIT:TEMP[?] [n]
Read or set the display temperature units, where “n” is a character “C” or “F”.
Default: C.
Read Example: UNIT:TEMP?
Response: C
Set Example: UNIT:TEMP F
To Next Page
Loading...
