44
SWer Output
This parameter is used to set a switcher's AUX crosspoint switch destination setting.
Refer to an "MFR-3000 Operation Manual," "MFR-5000 Operation Manual" or "MFR-8000
Operation Manual" for more details.
4-2-4. DP-MV Tally
The DP-MV Tally page allows you to assign a channel for each display ID.
Selects the ID for which to set settings.
If DP ID is selected: Selects a UMD ID (DP1-128)
If TSL ID is selected: Selects an MV window ID. (TSL1-127)
Selects a channel to assign to the selected ID.
Checking this checkbox displays the name entered under Content to
the UMD or MV window. Unchecking the checkbox displays the name
under Assign, the source name assigned to the channel.
Enters the name displayed on the UMD or MV window when the
checkbox under Display is checked.
Selects a tally color when the checkbox under Display is checked.
To Next Page
Loading...
