3.6 STORAGE
If the machine will not be used for an extended period, you must store the machine
correctly. If you prepare the machine carefully and apply on-going care you can prevent
deterioration and damage to the machine while it is in storage.
3.6.1 PREPARING THE MACHINE FOR STORAGE
1. Clean the machine to remove all unwanted material and corrosive products.
2. Dry the machine to remove solvents and moisture.
3. Apply grease to the moving parts.
4. Examine the machine for worn or damaged parts. Replace if necessary.
5. Fill the fuel tank to prevent a build up of condensation in the tank.
6. Examine all fluid levels. Top up if necessary.
7. Disconnect and remove battery (place in suitable storage).
8. Make sure tyre pressures are correct (low pressures can result in cracks in the
side wall).
9. Rotate the discharge chute so that it is positioned over the centre of the machine
or remove the discharge chute.
3.6.2 PUT INTO STORAGE
1. Park the machine on solid, level ground.
a. Park the machine in an area where it is easy to access. (In case the machine
does not start at the end of the storage period).
b. Put suitable timbers under the machine to eliminate direct contact with the
ground.
2. Remove the ignition key.
3. Remove the battery.
a. Keep the battery in warm, dry conditions.
b. Charge the battery periodically.
4. If you keep the machine outdoors, cover the machine with tarpaulins or plastic
sheets.
3.6.3 DURING STORAGE
Operate the machine functions each week to prevent a build up of rust in the engine and
hydraulic circuits and to minimise the deterioration of the hydraulic seals.
1. Remove any covers.
2. Examine all fluid levels. If necessary, add more fuel.
3. Install a charged battery.
4. Start the engine.
5. Operate the feed roller controls. Make sure that the feed roller functions operate
correctly.
6. Prepare the machine for storage.
Chapter 3: Transportation and storage
Redwood Global Ltd - ST6D42
Operator and Maintenance Manual
63 12-00-004 v2.1
To Next Page
Loading...
