4.3 STARTING THE MACHINE
Carry out daily checks before first use of machine everyday.
To start safely, follow the start up procedure below.
1. Insert the key into the ignition.
2. Make sure that the discharge chute is pointing in a safe direction.
3. Turn the key 90° clockwise.
The screen switches on.
Figure 35 - Key in the ON position
4. After the screen has switched on, turn the key 45° clockwise. Hold the key in this
position until the engine starts or the crank cycle finishes.
CAUTION
Do not operate the starter motor for more than 10 seconds. If the engine does
not start turn the ignition key to off, wait 30 seconds, and then start the engine.
Figure 36 - Key in the engine crank position
• If the engine doesn't fire, turn the key to the OFF position and return to step
3.
• If the engine doesn't fire after trying three times, check for faults.
►
For more information, refer to "Troubleshooting" on page 123
5. Once engine has started, allow the engine to idle for 30 seconds for the oil to
flow around the engine before slowly increasing the speed to maximum.
NOTICE
Increase and decrease the engine speed slowly, especially during the first 50
hours of operation.
Chapter 4: Operation
Redwood Global Ltd - ST6D42
Operator and Maintenance Manual
69 12-00-004 v2.1
To Next Page
Loading...
