Framery 2Q Huddle
3. Install the wooden backplate below the whiteboard brackets with 5x60 screws (4 pcs).
Note: Install the backplate in a butt joint with the whiteboard brackets.
Note: Use the U-profile seal as the midpoint reference.
4. Install magnets (2 pcs) below the wooden backplate. Measure 45 mm (1 ¾ in) from the
U-profile seal to the screw hole in the magnet and install with 4x40 screws (2 pcs).
Install the magnets with 15 mm plastic spacers.
The upper edge of the magnet touches the wooden backplate.
Note: Measure the distance from the outer edge of the U-profile seal to the
center of the magnet.
Installation instructions
info@frameryacoustics.com
179
To Next Page
