Framery 2Q - Page 87

Framery 2Q Huddle
5. Check the straightness of the pod slightly below the roof and wall module junction with
a spirit level.
6. Install the screws on the glass frames first on the front half of the roof and then on the
front half of the floor.
Use M8x35 bolts (2 pcs) and M8 washers (2 pcs) on the roof and black M8x50
countersunk screws (2 pcs) on the floor.
Note: Press the acoustic panel aside to reach the screw holes. Make sure that
you return the acoustic panel to its original position.
Note: Check with a spirit level that the hinge-side frame is straight. Push the
pod if needed when installing the screws.
Installation instructions
info@frameryacoustics.com
87