117
EN
tu1 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature on the booster located in the power source
Remedy: Place power source in a heated room and allow it to warm up
tu2 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature in the power source secondary circuit
Remedy: Place power source in a heated room and allow it to warm up
tu3 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature in the wirefeeder motor
Remedy: Place power source in a heated room and allow it to warm up
tu4 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature in the welding torch
Remedy: Place welding torch in a heated room and allow to warm up
tu6 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature on the power source transformer
Remedy: Place power source in a heated room and allow it to warm up
tu7 | xxx
Note: xxx stands for a temperature value
Cause: Undertemperature in the power source
Remedy: Place power source in a heated room and allow it to warm up
no | Prg
Cause: No preconfigured program has been selected
Remedy: Select a configured program
no | IGn
Cause: "Ignition time out" function is active; no current started flowing before the
length of wire specified in the set-up menu had been fed. The power source
safety cut-out has tripped.
Remedy: Shorten the wire end; press the torch trigger again; clean the surface of the
workpiece; if necessary, increase the wire length until the safety cut-out trips
in "Set-up menu: Level 2".
EPG | 17
Cause: The welding program selected is invalid
Remedy: Select valid welding program
EPG | 35
Cause: Measurement of the welding circuit resistance "r" failed
Remedy: Check grounding cable, current cable or hosepack and replace if necessary,
recalculate welding circuit resistance "r"
To Next Page
Loading...
