33
EN
No. Function
(6) "Parameter selection" button (left)
For selecting the parameters listed below
The relevant symbol lights up when a welding parameter is selected.
Sheet thickness in mm or in. *)
If the welding current to be selected is not known, it is sufficient to enter the sheet
thickness. The required welding current and any other parameters marked with *)
will then be adjusted automatically.
Welding current in amperes *)
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. The actual value is displayed during
welding.
Wire speed in m/min or ipm
*)
*) If one of these parameters is selected in the MIG/MAG standard synergic welding pro-
cess, then the synergic function ensures that all other synergic parameters are adjusted
automatically.
(6)
To Next Page
Loading...
