34
No. Function
(7) "Parameter selection" button (left)
For selecting the parameters listed below
The relevant symbol lights up when a welding parameter is selected.
Arc length correction
For correcting the arc length
Welding voltage in V *)
Before the start of welding, the device automatically displays a standard val-
ue based on the programmed parameters. The actual value is displayed
during welding.
Arc-force dynamic
For influencing the short-circuiting dynamic at the moment of droplet transfer
- ... harder, more stable arc
0 ... neutral arc
+ ... soft, low-spatter arc
Real Energy Input **)
For displaying the energy applied during the welding operation
*) If one of these parameters is selected in the MIG/MAG standard synergic welding
process, then the synergic function ensures that all other synergic parameters are
adjusted automatically.
**) This parameter can only be selected if the EnE parameter is set to ON in the Level
2 Setup menu. The value continuously rises during welding in line with the perma-
nently increasing energy yield. The final value at the end of welding remains stored
until welding starts again or the power source is switched back on - the HOLD indi-
cator lights up.
(7)
To Next Page
Loading...
