105
EN
SEt
Setting - Country-specific setting (Standard/USA) ... Std/US
Unit -
Setting range Std, US (Standard/USA)
Factory setting Standard version: Std (measurements: cm/mm)
USA version: US (measurements: inches)
E-P
External parameter - a user-defined welding parameter for the JobMaster TIG welding
torch or robot interface (both optional).
A freely selectable welding parameter is available both on the JobMaster TIG welding
torch and for the robot interface. If "E-P" has been selected, you can use the adjusting
dial to choose between the following possibilities for this freely definable welding param-
eter:
OFF No freely defined welding parameter has been assigned (factory setting)
ELd Electrode diameter
bAL Balance
SPt Spot welding time
I-S Starting current
UPS UpSlope
I-2 Reduced current
dsl DownSlope
I-E Final current
ACF AC frequency
F-P Pulse frequency
dcY Duty cycle
I-G Base current
tAC Tacking function: Duration of the tacking operation
Fd.1 Wire speed 1 (cold wirefeeder option)
The number of user-defined welding parameters depends on the configuration and the
mode that has been selected.
ACS
Automatic current switch - automatic switchover to main current
Unit -
Setting range ON / OFF
Factory setting ON
ON The welding parameter I
1
(main current) will automatically be se-
lected after welding has started.
The main current I
1
can be set immediately.
OFF The last selected welding parameter remains set during welding.
The last selected welding parameter can be set immediately. No
automatic selection of parameter I
1
takes place.
PPU
Select push-pull unit (cold wirefeeder option)
To Next Page
Loading...
Need help?
General
