106
FCO
Feeder control - Wirefeeder cut-out (wire end sensor option)
Unit -
Setting range OFF/ON/noE
Factory setting OFF
OFF The power source halts the wirefeeder when the wire end sensor
is triggered. "Err|056" appears on the display.
ON When the wire end sensor is triggered, the power source only
halts the wirefeeder after the current weld seam has been com-
pleted. "Err|056" appears on the display.
noE The power source does not halt the wirefeeder when the wire end
sensor is triggered. The wire end alarm is not displayed and is
only transmitted to the robot control via the field bus.
IMPORTANT! The "noE" setting only functions in conjunction with the field bus applica-
tions. Robot interfaces ROB 4000/5000 do not support this function.
COr
Correction - Gas correction ("Digital gas control" option)
Unit -
Setting range AUT / 1.0 - 10.0
Factory setting Aut
IMPORTANT! Please refer to "Digital gas control" Operating Instructions for more de-
tailed explanations of the "COr" parameter.
To Next Page
Loading...
Need help?
General
