Fronius TransTig 800 Job - Page 94

94
dYn
dynamic - arc force dynamic correction
Unit -
Setting range 0 - 100
Factory setting 20
For further information on the dYn parameter, see the rod electrode set-up menu.
HCU
Hot-Start current
Unit %
Setting range 0 - 200
Factory setting 150
dt1
delay time 1 - time by which the start of wirefeeding is delayed after the beginning of main
current phase I
1
(cold wire-feed unit option)
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
dt2
delay time 2 - Delay in the end of wirefeeding from the end of main current phase I
1
(cold wire-feed unit option)
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
Fdi
Feeder inching - Feeder inching speed (cold wire-feed unit option)
Unit m/min ipm.
Setting range 1,0 - max. 39.37 - max.
Factory setting 5 197
Fdb
Feeder backward - wire withdrawal (cold wire-feed unit option)
Unit mm in.
Setting range OFF / 1 - 50 OFF / 0.04 - 1.97
Factory setting OFF OFF
For further information on the Fdb parameter, see the TIG set-up menu.