Fuji Xerox DocuPrint C3290 FS User Manual

Control Panel Menus
9-3
Changing Menu Settings
Changing the Power Saver Time
In this example, you set the transitional time to the Power Saver Mode. For more information on the power
saver modes, see Power Saver Modes on page 2-10.
1. To display the
Setup screen, press the System button on the control panel.
2. Press the Up Arrow or Down Arrow button until
Admin Menu appears, and then press the Forward
Arrow or OK button.
3. Press the Up Arrow or Down Arrow button until
System Settings appears, and then press the
Forward Arrow or OK button.
4. Press the Up Arrow or Down Arrow button until
Power Saver Timer appears, and then press the
Forward Arrow or OK button.
5. Select
Mode 1 (Printer) or Mode 2 (System), and then press the OK button.
6. Press the Up Arrow or Down Arrow button to change the number of minutes that the printer will wait
before entering the Power Saver mode.
7. Press the OK button to confirm your settings.
Note: If you want to change values after you have confirmed them by pressing the OK button, you need to
set them from the start again.

Fuji Xerox DocuPrint C3290 FS Specifications

General

Brand	Fuji Xerox
Model	DocuPrint C3290 FS
Category	All in One Printer
Language	English