Control Panel Error Messages
10-32
Messages About the Printer and Other Items
Message Condition/Reason/Action
Printer Too Hot
Error 042-700
Cooling down
Please Wait...
The printer’s internal temperature is too high.
The printer has been stopped. Wait 1 hour before restarting the printer.
Ensure the printer has adequate cooling space around it, and that the
cooling vents are not blocked.
Insert Tray 2
Tray 2 is pulled out.
Push Tray 2 into the correct position.
Controller Error
Error 116-327
and -328
Restart Printer
An internal controller error occurred.
Restart the printer.
Disabled Func
Error 016-758
Press OK
The function that you are trying to access has been disabled.
Enable the function through the control panel menus, or contact your printer
administrator. See Using the Control Panel Menus and Keypad on
page 9-1.
Door A Open
Close Door A
The front cover is open.
Close the front cover.
Fan Motor Error
Error 042-3NN
Restart Printer
An error has occurred with the fan.
Restart the printer. If the error continues, contact Fuji Xerox local
Representative Office or Authorised Dealers.
Fuser Error
Error 010-397
Error Code: xx
Restart Printer
A fuser error has occurred.
Restart the printer. If the error continues, contact Fuji Xerox local
Representative Office or Authorised Dealers.
Invalid Job
Error 016-799
Press OK
When the configuration of the printer on the print driver does not conform to
the printer you are using, this message appears.
Press the Stop button to cancel the print job.
Make sure that the configuration of the printer on the print driver conforms
to the printer you are using.
Invalid User
Error 016-757
Press OK
The user is not registered to print on the printer when using an
authentication function.
Contact the administrator.
Jam at Tray 1
Check Tray 1
Open Door A
Paper is jammed inside Tray 1 (MPT).
Remove the jammed paper. Open and close the front cover. See Paper
Jams on page 10-2.
Limit Exceeded
Error 016-759
Press OK
The user has exceeded the limit on the number of pages that can be printed
when using an authentication function.
Contact the administrator.
To Next Page
Loading...
