Description of Menu Items
9-10
PostScript Settings
■ PS Error Report: Specifies whether an error report is printed when a PostScript error occurs.
■ PS Job Time-Out: Specifies the maximum execution time for a PostScript job to complete. If the job
exceeds the specified number of minutes, a PostScript error occurs.
■ Paper Select Mode: Specifies how the tray is selected for PostScript print jobs.
■ Auto
The tray is selected as set in PCL mode.
■ Select From Tray
The tray is selected in a method compatible with regular PostScript printers.
Note: Changes to PS Job Time-Out and Paper Select mode settings require that the printer be turned off
and on to make them effective.
Network
Specifies printer settings affecting jobs sent to the printer through a network port.
The settings in the Network Settings menu cannot be set when entering this menu during printing.
You need to restart the printer to activate the new settings. After making the settings, turn off the printer,
and then turn it back on again.
■ Ethernet: Specifies the communication speed and the modes of Ethernet.
■ Auto (default): Automatically detects 10Base Half, 10Base Full, 100Base Half, and 100Base Full.
■ 10Base Half: Uses 10base-T half-duplex.
■ 10Base Full: Uses 10base-T full-duplex.
■ 100Base Half: Uses 100base-TX half-duplex.
■ 100Base Full: Uses 100base-TX full-duplex.
■ TCP/IP: Specifies the TCP/IP settings for the network.
■ Get IP Address: Specifies whether to automatically or manually retrieve the IP address.
DHCP/Autonet (default) Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address automatically.
RARP Uses RARP to set the IP address automatically.
DHCP Uses DHCP to set the IP address automatically.
Panel You can set the IP address manually by entering
it on the control panel.
To Next Page
Loading...
Need help?
General
