Description of Menu Items
9-15
■ Extel Hook Thresh: Specifies the threshold value for the external telephone.
■ Country: Specifies the country where the printer is used.
Note: Country must be set before faxes can be sent.
■ Fwd. Error Print: To print the documents failed to transfer when Fwd. Set Print is set to Off.
■ Off: Does not print documents that fail to transfer when Fwd. Set Print is set to Off.
■ On: Prints documents that fail to transfer when Fwd. Set Print is set to Off.
System Settings
The System Settings menu is used to configure basic printer settings, such as for alarm and power saver
mode.
■ 2 Mode Power Saver?: Specifies if both power saver modes are enabled. When set to Enabled both
Mode 1 and Mode 2 are enabled. When disabled, only Mode 1 is enabled.
■ Power Saver Timer: Specifies the transitional time of Power Saver Modes 1 and 2 in increments of
1 minute.
■ Mode 1 (Printer): 5 min. to 60 min. (default is 5 min.)
■ Mode 2 (System): 1 min. to 6 min. (default is 6 min.)
For details, refer to Power Saver Modes on page 2-10.
■ Auto Reset: Specifies the time the printer waits for further control panel input before automatically
resetting the settings for COPY, SCAN, or FAX and returning to the standby mode.
■ Alert Tone: Specifies whether to turn on the alarm when an error occurs in the printer.
■ Panel Select Tone (default: Normal)
■ Panel Alert Tone (default: Offl)
■ Machine Ready Tone (default: Normal)
■ Copy Job Tone (default: Normal)
■ Non-Copy Job Tone (default: Normal)
■ Fault Tone (default: Normal)
■ Alert Tone (default: Normal)
■ Out of Paper (default: Normal)
■ Low Toner (default: Off)
■ Auto Clear Alert (default: Off)
■ Base Tone (default: Off)
■ All Tones
To Next Page
Loading...
Need help?
General
