Description of Menu Items
9-18
Maintenance
Use this menu to initialize the NVM, to configure security setting, or to adjust the configurations for each
type of paper.
■ Auto Regi Adjust: Adjusts the color registration automatically. Selecting On adjusts the color
registration automatically. The default is On.
■ Adjust ColorRegi: Correct the color registration manually. For details, refer to Color Registration on
page 10-23.
■ Auto Correct: Corrects the color registration automatically.
■ Color Regi Chart: Prints the correction chart.
■ Color Regi: Enter the number to correct the registration.
■ Initialize NVM: Initializes the settings stored in the NVM except for the network settings. The NVM
is a nonvolatile memory that stores the printer settings even after the power is turned off. After
executing this function and restarting the printer, all the menu parameters are reset to their default
values.
■ You cannot initialize the NVM during printing.
■ You need to restart the printer to activate this setting. After making the setting, turn off the printer,
and then turn it on again.
■ Init PrintMeter: Initializes the print meter.
■ Custom: Specifies whether to use non-genuine print cartridges.
Important:
■ Non-genuine toner may seriously damage the printer. Damage caused by Non-genuine toner may
not be covered by your warranty.
■ Unless all the copy jobs that are stored in the printer are completed, this setting cannot be changed.
Secure Settings
Use the Secure Settings menu to set a password to limit access to the menus.
■ Panel Lock: When enabled, access to the Admin Menu requires a password.
■ Scan/Fax Lock: When enabled, access to the scanner and fax requires a password. Panel Lock must
be enabled before enabling Scan/Fax Lock.
■ Secure Receive Lock: When enabled, incoming faxes require a password to print them. Panel Lock
must be enabled before enabling Secure Receive Lock.
To Next Page
Loading...
Need help?
General
