Print Quality
10-20
Blank pages Two or more sheets may be feeding at once.
Remove the paper stack from the tray, fan it, and reinsert it.
The print cartridges are not genuine print cartridges.
Verify that the print cartridges (C/M/Y/K) are genuine cartridges, and replace if
necessary.
The transfer unit is old or damaged.
Replace the transfer unit.
The high-voltage supply is defective.
Contact Fuji Xerox local Representative Office or Authorised Dealers.
Hair-like marks appear in
or around black half-tone
printing Shadows appear
around areas of dense
black printing
The paper was left unwrapped for a long time (especially in a dry environment).
Replace the paper. See About Paper on page 5-6.
The paper is outside the recommended specification range.
Replace the paper with a recommended size and type, and confirm that your print
driver settings are correct. See About Paper on page 5-6.
The transfer unit is old or damaged.
Replace the transfer unit.
Color around the edge of
printing is incorrect
The color registration is incorrect.
Adjust the color registration. See Color Registration on page 10-23.
Colored dots are printed at
regular intervals (about 28
mm)
The print cartridge is dirty.
Clean the print cartridge.
Partial blanks, creased
paper, or blotted printing
The paper is damp.
Replace the paper.
The paper is outside the recommended specification range.
Replace the paper with a recommended size and type. See About Paper on
page 5-6.
The transfer unit, or fuser, is not installed correctly.
Reinstall the transfer unit and/or fuser.
The print cartridges are not genuine print cartridges.
Verify that the print cartridges (C/M/Y/K) are genuine cartridges, and replace if
necessary.
Condensation inside the printer causes partial blanks or creased paper.
Turn the printer on, and leave it on, for at least one hour to get rid of the
condensation. If the problems still occurs, contact Fuji Xerox local Representative
Office or Authorised Dealers.
Symptom Reason/Action
To Next Page
Loading...
Need help?
General
