Fuji Xerox DocuPrint C3290 FS User Manual

Problems With the Printer
10-27
Cannot send or receive fax Is the printer connected to an analog phone outlet?
If not, connect the printer to a known good analog phone outlet.
Are the fax parameters configured properly?
Verify that the fax parameters have been set correctly.
Print job sent but the light
of the Ready indicator is
not blinking or on
Is the interface cable disconnected?
Turn off the power and check the connection of the interface cable.
Is the protocol configured?
Check the port status of the interface. Make sure the protocol settings are correctly
configured in CentreWare IS. See the Online Help for CentreWare IS.
Is the computer environment correctly set up?
Check the computer environment, such as the print driver. See Network Basics on
page 4-1.
Error indicator is on Is there an error message displayed on the control panel?
Check the displayed message and correct the error.
Error indicator is blinking An error that you cannot correct by yourself has occurred.
Record the displayed error message or error code, turn off the power, pull out the
power plug from the outlet. Contact Fuji Xerox local Representative Office or
Authorised Dealers.
Light of the Ready
indicator is on and blinking
but there is no print output
There are jobs remaining in the printer.
Cancel printing or force the remaining data to be printed.
To forcibly print the job, press the OK button. To cancel the job, press the Stop
button.
Top section of printed
document is missing. The
top and side margins are
incorrect.
Are the paper tray guides in the correct positions?
Set the length guide and the width guides to the correct positions. See Loading Paper
in Trays 2 and 3 on page 5-12.
Check that the paper size on the print driver or the control panel is correctly set.
See the Online Help for the print driver. See Setting Paper Types and Sizes on
page 5-8.
Check that the margin setting is correct on the print driver. (PCL only)
See the Online Help for the print driver.
Condensation has
occurred inside the printer
Turn the printer on, and leave it on, for at least one hour to get rid of the
condensation. If the problem continues, contact Fuji Xerox local Representative
Office or Authorised Dealers.
Symptom Reason/Action

Fuji Xerox DocuPrint C3290 FS Specifications

General

Brand	Fuji Xerox
Model	DocuPrint C3290 FS
Category	All in One Printer
Language	English