Printing on Specialty Media
5-24
Loading Transparencies
Note: Transparencies with a white frame and full-color transparencies cannot be used.
1. After carefully fanning a small stack of transparencies, load them into Tray 1 (MPT) with the side to be
printed facing down. Load no more than 25 transparencies at a time.
2. Slide the paper guides to the size of the transparencies.
Printing on Transparencies
When MPT Mode is set to Panel Specified, you need to set the paper type and size settings for the tray on
the control panel in advance. See Setting Paper Types and Sizes on page 5-8.
The way to display the printer Properties dialog box differs according to the application software. Refer to
the manual of your respective application software.
Printing transparencies continuously may lead to the output transparencies sticking to each other. Remove
the transparencies from the output tray after about 20 sheets, and then fan them to lower their temperatures.
To Next Page
Loading...
Need help?
General
