Important
: Network Convertor will not operate if,
● VRF network system address (Outdoor & Indoor units address) allocation information
are not registered to Network Convertor.
● XIF data information and VRF network system address allocation information must
not be same.
● Binding & Commissioning is not executed. (During binding, read out the Network
Convertor Neuron ID by pushing BMS service switch (SW 2) on the main PCB of
Network Convertor)
● If the ID number registered to the Network Convertor is not same as the ID number
which is included in the XIF of Network Convertor.
- (05 - 145) -
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
