z
Filter mode setting
Set the Filter mode to suppress an increase of the amount of communication information in the VR-II system.
● Filter mode is turned on by inserting the accessory connecting wire at the CN4 connector on the PCB.
● When the Filter mode setting is changed, turn the power off once. Otherwise, the setting will not be recognized.
CN4
Body
PCB
Connecting wire (Accessory)
DIMENSIONS
Unit: in. (mm)
8-5/16 (211)
9-1/2 (241.6)
11-5/16 (288)
2-Ø5 (3/16)
2-5/8
(67)
3-1/2
(89.5)
3-1/2
(89.5)
1-1/8
(29)
Ø1-1/8 (28)
For dust proof
bushing
4 - Ø3/16 (5) For M4x20mm screws
Ø 1-1/8(28)
For dust proof bushing
For M4x20mm
screws
10-11/16 (272) Hole pitch
Hole pitch
3-3/4 (95)3-3/4 (95)
Hole pitch
Ø7/8 (22.2) For conduit
- (05 - 173) -
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
