Fujitsu Airstage J-II Series User Manual


ADDRESS SETTING
z
Indoor unit address setting
5) Pressing the SET BACK button, select a remote controller address (select the indoor unit
you want to operate).
Ex.) When remote controller address “01” is
selected
Remote controller address
6) Pressing the SET TIME < button or the SET TIME > button, display function number 01.
Function number
7) Pressing the SET TEMP. V button or the SET TEMP. Λ button, set up the indoor unit
address. (The setting range is from 00 to 63.)
Ex.) When indoor unit address data “12” is set up
Indoor unit address data
8) Pressing the TIMER SET button, conrm the selected indoor unit address data.
(The data will be transferred to the indoor unit.)
ERROR
● When indoor unit address data was not set
up on the indoor unit (-- is displayed.)
● Set up indoor unit address data again
according to the procedure in step 7) above.
GOOD
When indoor unit address data was normally set
up on the indoor unit
(Flashing display changes to illuminated display.)
- (07 - 25) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English