Fujitsu Airstage J-II Series User Manual


SWITCHING SELECTION OF ADDRESS SETTING MODE
4) To activate the address setting mode, hold down the three buttons of SET TEMP.
q
, SET
T E M P.
p
and FAN at the same time for 5 seconds or longer.
Address setting mode initial display

BUTTON NAME AND FUNCTION
● Refer to “5-2” for an outline of the address setting.
● It does not matter whether the refrigerant circuit address or indoor unit address is set first.
(The method shown here sets the indoor unit address first.)
● During address setting mode, indoor unit reject the any operation command from remote controller.
Function number
01---Indoor unit address
02---Refrigerant circuit address
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Setting number
● Indoor unit address valid range 00-63
● Refrigerant circuit address valid
range 00-99
START/STOP button
Transmits address setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers.
UTY-RSKU (With operation mode)
Function number
01---Indoor unit address
02---Refrigerant circuit address
Remote controller address
Remote controller address
setting number 00-15
FAN button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Setting number
● Indoor unit address valid range 00-63
● Refrigerant circuit address valid
range 00-99
START/STOP button
Transmits address setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers.
UTY-RHKU (Without operation mode)
- (07 - 40) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English