Fujitsu Airstage J-II Series User Manual


ADDRESS SETTING
z
Indoor unit address setting
5) Pressing the SET TEMP.
p
button or SET TEMP.
q
button, select a remote controller
address (select the indoor unit you want to operate).
Ex.) When remote controller address “01” is selected
Remote controller address
6) Press the FAN button so that the “Function number” display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to display function number “01.”
Function number
7) Press the FAN button so that the “Setting number” display ashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the indoor unit address data. (The
setting range is from 00 to 63.)
Ex.) When indoor unit address data “12” is set up
Indoor unit address data
8) Pressing the START/STOP button, conrm the selected indoor unit address data. (The
data will be transferred to the indoor unit.)
ERROR
When indoor unit address data was normally set
up on the indoor unit.
● When indoor unit address data was not set up
on the indoor unit (-- is displayed.)
● Set up indoor unit address data again
according to the procedure in step 7) above.
GOOD
- (07 - 41) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English