SETTING UP EACH INDOOR UNIT
Repeat steps (1) through to (16). Steps (1) through to (5)
and (13) to (16) only need to carried out if the custom
code is dierent to the factory setting of “A”.
RESET THE POWER AFTER SETTING UP FUNCTION OF ALL
INDOOR UNITS
Important
●
If the reset is not performed, function cannot be read in normally.
●
After all the functions have been set, the circuit breaker needs to be switched off for
at least 2 minutes.
After the 2 minutes has passed, power can be restored.
●
The set function is stored in the PCB and will remain in memory even when the
power is turned off.
However, the address can be reset after power reset (if needed).
Record the function set in the indoor unit on a label, etc., and ax the label to the
unit so it can be used for after-sales service operations.
¾
Number 0 setting will not indicate TIMER LAMP and FILTER LAMP.
¾
Once the "RESET" button is pressed on the remote controller, the OPERATION MODE will be
set in the "AUTO MODE".
Adjust the OPERATION MODE to either "COOLING" or "HEATING" before trying to operate
the air conditioner.
¾
NOTE:
If CUSTOM CODE is set to anything other than "A", the remote control must be set
accordingly to the INDOOR UNIT setting.
01-01 01-02 01-03
- (07 - 95) -
FUNCTION
SETTING
FUNCTION
SETTING
To Next Page
Loading...
Need help?
General
