Fujitsu Airstage J-II Series - Page 748


SWITCHING SELECTION OF FUNCTION SETTING MODE
3) To activate the function setting mode, hold down the three buttons of SET TEMP. V, SET
TEMP. Λ and FAN at the same time for 5 seconds or longer.
Address setting mode initial display

BUTTON NAME AND FUNCTION
● During address setting mode, indoor unit reject the any operation command from remote controller.
Function number
Refer to FUNCTION DETAILS
Remote controller address
Remote controller address
setting number 00-15
SET BACK button
Switches the remote controller
address setting number.
SET TIME “<” and “>” button
Switches the function number.
Setting number
Refer to FUNCTION DETAILS
SET TEMP. “V” and “
Λ
” button
Switches the setting number.
TIMER SET button
Transmits function setting
- (07 - 101) -
FUNCTION SETTING FUNCTION SETTING