Fujitsu Airstage J-II Series User Manual


FUNCTION SETTING
4) Pressing the SET BACK button, select a remote controller address (select the indoor unit
you want to operate)
Ex.) When remote controller address “01” is
selected
Remote controller address
5) Pressing the SET TIME < button or the SET TIME > button, to select the function number.
Function number
6) Pressing the SET TEMP. V button or the SET TEMP. Λ button, to select the setting number.
The display ashes during setting number selection.
Ex.) Function number : 30, Setting number : 01
Setting number
7) Pressing the TIMER SET button, conrm the setting.
(The data will be transferred to the indoor unit.)
ERROR
● When the data was not set up on the indoor
unit (-- is displayed.)
● Set up the data again according to the
procedure in step 5), 6) above.
GOOD
When the data was normally set up on the indoor
unit
(Flashing display changes to illuminated display.)

FUNCTION DETAILS
Refer to 2-8. FUNCTION DETAILS.
- (07 - 102) -
FUNCTION SETTING FUNCTION SETTING

Fujitsu Airstage J-II Series Specifications

General

Brand	Fujitsu
Model	Airstage J-II Series
Category	Air Conditioner
Language	English