Fujitsu Airstage J-II Series - Page 753


FUNCTION SETTING
This procedure changes the function settings used to control the indoor unit according to the installation
conditions. Incorrect settings can cause the system to malfunction. Perform the “Function setting” according to the
installation conditions using the remote controller.
● Prepare for setting of indoor unit referring to installation manual of indoor unit before start of function setting.
● Refer to the indoor unit installation manual for details on the function numbers and setting numbers.
9) Select the 2-wire remote controller address with the SET TEMP. “ ” or SET TEMP. “ ”
button. Then press the “ ” button.
Select all
Select the 2-wire remote controller
address (Ex. Select the 002-03)
10) Set the function number with the SET TEMP. “ ” or SET TEMP. “ ” button. Then press
the “ ” button.
Function number
11) Set the setting number with the SET TEMP. “ ” or SET TEMP. “ ” button. Then press
the “ ” button.
Setting number
12) Setting results are displayed after data transmission.
- (07 - 106) -
FUNCTION SETTING FUNCTION SETTING