CT114_Rev2
Safety Information
Disconnect the AC power cord from the AC adapter plug or the wall outlet
immediately if a user observes the following:
• Fumes, bad smell, noise, or overheating occurs.
• Liquid or foreign matter falls into this product.
• The Cleaver or AC adapter is damaged or dropped.
If any of these occur, contact our service center for repair. Leaving the c
leaver or
AC adapter in a damaged state may cause equipment failure, electric shock, or fire
and may result in personal injury or death.
The AC adapter supplied with this product is the only adapter approved for use
with this product.
Using an improper AC power source may cause equipment damage, fumes,
electric shock, or fire and may result in personal injury or death.
Do not disassemble or modify the cleaver or the AC adapter in any way. In
particular, do not remove or bypass any electrical or mechanical device (e.g. a fuse
or safety switch) incorporated into the design and manufacturing of this equipment.
Modification could cause damage that may result in electric shock, fire, personal
Connect AC power cord properly to the AC Adapter and to the wall outlet. When
inserting the AC plug, make sure there is no dust or dirt on the terminals. Insert
the female plug into the AC Adapter and the male plug into the wall outlet until both
plugs ar
e fully seated. Incomplete engagement may cause fuming, electric shock,
equipment damage, or fire and may result in personal injury or death.
Disconnect
the AC power cord when the cleaver is not being used.
Use the supplied AC power cord. Do not place heavy objects on the AC power
cord. Use of an improper or damaged cord may
cause equipment failure, electric
shock, or fire and may result in personal injury or death.
Do not touch the cleaver, AC power cord and AC plugs with wet hands. This may
result in electric shock.
Do not operate the cleaver near hot objects, in hot environments, in dusty / humid
environments, or when condensation is present on the unit. This may result in
electric shock, cleaver malfunction, or poor cleaving performance. When water
condensation is present, leave the cleaver powered off and allow to air-
dry at room
temperature for at least 24 hours.
To Next Page
Loading...
Need help?
General
