Fujitsu CT114 User Manual

CT114_Rev2
75
Error Message List
Error Message List
Follow the solution as shown in the list below. If the listed solution does not eliminate the
problem, the cleaver may require service by a qualified servicer. Consult an authorized
distributor and provide the following information:
࣭
࣭
Model name
࣭
Serial number
࣭
Situation when the error occurs
Error Message
Reason
Solution
F
iber Broken!
Improper blade position
Execute [Blade Adjustment] from the [Maintenance
Menu].
Improper backstop
position
Adjust backstop position.
*Refer to [Loading Fiber in Cleaver] section.
Dust or dirt on the
lower insert
Clean the clamp.
*Refer to
the [Daily Maintenance] and [Loading
Fiber into the Cleaver] section.
Clamp not closed
properly
Confirm the release latch closes completely when
clamps
are closed.
Fiber Slip!
Dust or dirt on the
clamp
Clean the clamp.
*Refer to
the [Daily Maintenance] and [Loading
Fiber into the Cleaver] section.
Clamp force too we
ak
Increase
the [Left/Right Clamp Force].
Improper insert
installed
Select and install proper insert.
Refer to [Insert selection guide].
Too High Tension!
“ Tension Fine Adjust”
is set too low
Increase the value of [Tension Fine Adjust]
Too Far Blade!
Starting position of the
cleaver blade is too far
away from the fiber
Execute [Blade Adjustment].

Fujitsu CT114 Specifications

General

Brand	Fujitsu
Model	CT114
Category	Measuring Instruments
Language	English