USING SETUP MODE
User's Manual 5-55
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<FCNT-PE> Detection of end of front continuous
forms.
TRACTOR
Paper end is detected by the sensor
on the tractor unit.
Paper-end unprinted area:
Continuous forms: About 101 mm
EDGE
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area: About 4
mm for both continuous forms
<RCNT-PE> Detection of end of rear continuous
forms.
TRACTOR
Paper end is detected by the sensor
on the tractor unit.
Paper-end unprinted area:
Continuous forms: About 157 mm
EDGE
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4 mm for both continuous
forms
To Next Page
Loading...
