Getting started
Connecting external devices to the serial interface
SerialinterfaceSerialinterface,Externaldevices,Devices,
External devices can be connected to the serial interface (e.g. a printer or modem).
► Connect the data cable to the external device.
► Connect the data cable to the corresponding serial interf ace.
For an exact description of how to connect ext ernal devices to the corresponding
port, please see the external device documentation.
Port settings
Serialinterface,
You can change the port settings (e.g. address, interrupt) in the BIOS Setup.
Device drivers
Deviced rivers,
The devices connected to the serial interface req uire drivers. Your operating system
already includes many drivers. If the required drive is missing, install it. The latest
drivers are u sua lly available on the Internet or will be supplied on a data carrier.
Connecting external devices to the USB ports
USBdevices,USB port,Externaldevices,Devices,
You c an connect a wide range of external devices to the USB ports (e.g.
printer, scanner, modem or keyboard).
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in the documentation for the USB devices.
► Connect the data cable to the external device.
► Connect the d
ata cable to one of the USB ports on your device.
Device drivers
The extern
al USB devices you connect to the USB ports usually require no
driver of t
heir own, as the required software is already included in the operating
system. H
owever, if the external USB device requires its own software, please
install i
t from the data carrier provided with the USB device.
To ensur
e the transmission capacity of USB 2.0, the cable from the external USB
device t
o the USB port of your device must not be longer than 3 m.
20 Fujitsu
To Next Page
Loading...
