Fujitsu Esprimo E5 Series - Heat Sink Installation and Removal; Upgrading System Memory (RAM)

System expan sio ns
Installing and removing heat si
nks
Removing the heat sink
► Remove the casing cover (see Chapter "Removing the casi ng cover", Page 37).
► Disconnect the fan cables from th e m ainboard.
1
1
1
12
► Undo the screws (1).
► Remove the heat sink from the casing (2).
Never operate th e device without the heat sink fitted! Reinstall the
heat sink before switching on the device.
Installing the heat sin k
2
2
2
2
1
► Insert the heat sink into the casing (1),
making sure to correctly align the screw
holes on the heat sink with the screw holes
on the mainboa rd a n d taking note of the
arrows o n the heat sink. The arrows must
point to the rear of the device.
► Tighten the screws (2) in a crosswise
fashion.
► Connect the fan cables to t he mainboard.
► Fit the casing cover back onto th e casing (see Chapter "
Reattaching the casing cover.", Page 38).
Mainboard expansions
Details on how to upgrade the m ain memory or the processor of your device
can be found in the manual for the mainboard.
UpgradesLithium bat teryProcessorMainmemoryMainboa rd
Upgrading main memory
► Remov
e the casing cover (see Chapter "
Removing th e casing cover", Page 37).
Mainmemory,
► Upgrade the memory according to the description in the manual for the mainboard.
► Fit t
he casing cover back on to th e casing (see C hapter "
Reattaching the casing cover.", Page 38).
Fujitsu 63