System expan sio ns
System expansions
Upgrades,Device,System expansionComponentsServicing
Repairs to the device must only be performed by qualified technicians. Incorrect repairs
may greatly endanger the user (electric shock, fire risk) and will invalidate your warranty.
After consulting the Hotline/Help Desk, you may r emove and install the components
described in this ma nual yourself.
As the device has to be shut down in order to install/deinstall system hardw are
components, it is a good idea to print out the relevant sections of this chapter beforehand.
The following illustrations may differ slightly from your device, depending on its configuration level.
If further documentation was delivered with your dev ice , please also read this through carefully.
In addition, before removing or insta lling system components, please pay a ttention to the following:
The device must be switched off when installing/removing the s ystem
expansions and may not be in energy-saving mode.
Remove the power plug before opening the device.
Be careful that no wires b ecome trapped when removing or installing compone nts.
When installing components that become very hot, make sure that the maximum
permissible temperature of the components in operation is not exceeded.
An update of the BIOS may be required for a system expansion or hardware
upgrade. Further information can be found in the BIO S help section or if
necessary in the Tech nical Manual for the mainboard.
Fujitsu 35
To Next Page
Loading...
Need help?
General