▶
Remove the power cord from the defective PSU, see "Disconnecting the
power cord" on page 46.
Removing the defective hot-plug PSU
▶
Remove the PSU, see
"Removing a hot-plug PSU" on page 108.
Installing the new hot-plug PSU
▶
Install the PSU, see "Installing a hot-plug PSU" on page 105.
Concluding steps
▶
Connect the power cord to the new PSU and secure it with a cable clamp,
see"Connecting the power cord" on page 56.
▶
Only when replacing a PSU in a non-redundant configuration: "Switching on
the server" on page 58.
▶
"Performing a fan test" on page 96.
6.4.5 Replacing the power distribution board
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 43.
▶
"Suspending BitLocker functionality" on page
65.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
Power supply unit (PSU)
114 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
