Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

10 Main memory
10.1 Safety notes
CAUTION
▶
Before removing several memory modules, make sure that all
memory modules can be reinstalled into their original slots.
Otherwise, data may be lost.
▶
Do not install unsupported third party memory modules. For more
information on supported memory modules, see "Basic
informations " on page 234
. Doing so may cause electric shock, a
fire, or failures.
▶
Memory modules remain hot after shutdown. Wait for components
to cool down before installing or removing memory modules to
prevent burns.
▶
Do not install and remove memory modules repeatedly. Doing so
may cause failures.
▶
If the memory module has not been correctly installed, it may cause
a fire. Install the memory module with attention.
Pressing out the securing clips on the memory module connector
will eject the installed memory module. To prevent damage and
injuries eject memory modules carefully without applying excessive
force.
▶
For more information, see "Important information" on page 29.
RX1330 M4 Upgrade and Maintenance Manual 233

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller