For the cable plans, see "Appendix B" on page 365.
Concluding steps
▶
Insert all HDD/SSD modules, see "Installing 2.5-inch HDD/SSD modules"
on page 152
.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶
"Reassembling" on page
52
.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 58.
7.5.8 Replacing the SAS expander board
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 43
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
Removing the defective SAS expander board
▶
Remove the SAS expander board, see "Removing the SAS expander
board" on page 168.
Hard disk drive (HDD) / solid state drive (SSD)
172 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
