Figure 22: Progress bar (RAID array rebuild)
CAUTION
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the
HDD capacity the overall process can take up to several hours, in some
cases even days.
You may notice a slight performance impact during rebuild.
5.3.16 Looking for MAC/WWN/GUID and SAS addresses
5.3.16.1 Basic information
The customer needs to know the new address of the controller:
–
When replacing the system board with an onboard LAN controller
–
When adding or replacing a network controller
–
When adding or replacing a SAS controller
Basic software procedures
88 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
